Would you like to learn how to make beautiful, transparent fairy wings for your dolls? Check out my new video tutorial to learn how!
Products used in the video:
Transparency Film – Inkjet: https://amzn.to/2Jbncrb Laser: https://amzn.to/2PKRPGl
Judikins Diamond Glaze glue – 8 oz/237 mL: https://amzn.to/2R9OYqW 2 oz/60 mL: https://amzn.to/2SbOG4f
Needle tip reusable bottles – https://amzn.to/2D0TgOy
Utility wire – https://amzn.to/2PQZ147
White Floral tape – https://amzn.to/2S90x2W
PearlX Powders – https://amzn.to/2PMEwWc
Martha Stewart Glitter – https://amzn.to/2PKTFXL
Flatback crystals mixed sizes – AB finish: https://amzn.to/2CZEo2M Clear: https://amzn.to/2ScygIY
Looking for fairy patterns?: https://kelibudesign.com/?s=fairy&post_type=product
QUESTION — Have a question about KeLibu Patterns, Embellishing, or Anything Else? Post in comments section of this video! Looking for fairy costumes for your dolls? Check out KeLibu’s selection of fairy patterns: https://kelibudesign.com/?s=fairy&post_type=product
Subscribe to KeLibu Design here: https://www.youtube.com/channel/UCOiAxhIWXNi4JfEkW-qH1Aw?sub_confirmation=1
KeLibu on Social Media:
Music credits: Happy Life, Beautiful and Positive Pop by AShamaluevMusic https://www.ashamaluevmusic.com
DISCLAIMER: This video and description contains affiliate links, which means that if you click on one of the product links, I’ll receive a small commission. This helps support the channel and allows me to continue to make videos like this and new patterns. Thank you for the support!
Strange question… how can you attach the wings if your doll has an outfit that doesn’t have the special hole to slip them into (like in the outfit your model is wearing)? I’m sure one could just make the outfit… but what if the doll’s companion wants to have the doll wear something else without the convenient hole and have wings too?
Hi Krystyl! The outfit doesn’t have a special hole…it’s just the back of the shirt. So as long as your bodice is low enough to place the wings at a good spot on the back and tight enough to hold them in place, this will work. (i.e. if you had a strapless dress on your doll, you could slip the U into the back of the dress.) Sometimes this won’t work so in that case, you’ll have to alter your wires a bit.
I will add a blog post showing a diagram of how you would do that.
I’ve added a post about an alternate wire configuration for these wings in the Make It…Change It! section of the blog.
These wings are amazing!
Thank you Chris!
Do you add any water to your glue to make it come out so nice and easy?
Hi Kimmi. I didn’t add any water to the Diamond Glaze…it comes with that consistency. However, I did notice that my older bottle had thickened up slightly. Since this adhesive is water based, you could add a little bit of water to it to thin it if needed.